Filter
Top Products
17 Printer Environment Settings
4
If the operating system on the client is Mac OS X 10.3.9 or later, enable the Bonjour port,
and the Discovery feature that automatically detects printers on the IP network can be
enabled.
Note • To print from a printer detected by Bonjour, the LPD port must be enabled in advance.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Bonjour], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
5
Select [Close] repeatedly until the [Tools] screen is displayed.
6
Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
7
Print a configuration report to confirm that the LPD port is enabled and that TCP/IP is set
up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.260).
8
Configure other LPD or Port 9100 settings as necessary.
For information on how to set up the LPD port or Port 9100, refer to "Dell Printer Configuration Web
Tool Setting Items" (P.432).
Step 3 Configuration on the Computer
To print from the machine, you need to install a print driver on your computer.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.428).
For information on the driver installation procedures, refer to the manual contained in the Driver CD
Kit.
You can print via TCP/IP (LPD) from a Macintosh computer for Mac OS X 10.5/10.6/10.7/10.8. For
information on the installation procedures of the print driver for Mac OS X, refer to the manual
contained in the CD-ROM provided with the driver.
Dell Printer Configuration Web Tool Setting Items
You can configure the following setting items using Dell Printer Configuration Web Tool:
For information on how to start Dell Printer Configuration Web Tool, refer to "Starting Dell Printer
Configuration Web Tool" (P.420).
• Spool Destination for Jobs
([Properties] > [General Setup] > [Memory Settings] > [LPD])
Note • The spool destination can be configured when the LPD port is enabled.
• Receiving buffer size for Port 9100
([Properties] > [General Setup] > [Memory Settings] > [Port 9100])
• Port Settings
•IP Mode
•Host Name
•IPv4
- IP Address Resolution
- Port Settings
432