Filter
Top Products
3 Copy
Step 4 Starting the Copy Job
The following describes how to start a copy job.
1
Press the <Start> button.
Note • If the document has been loaded in the
document feeder, do not hold down the
document while it is being conveyed.
• Move the lever of the fusing unit down to set
to the Envelope mode before copying on an
envelope. Return the lever to its original
position before copying on other types of
papers. Any type of paper other than envelope
cannot be copied while the lever is set to the
Envelope mode position. For information on
how to switch the lever of the fusing unit, refer
to "Loading an Envelope in Trays 1 to 4" (P.209) or "Loading an Envelope in Tray 5 (Bypass Tray)" (P.212).
• If a problem occurs, an error message appears on the touch screen. Solve the problem according to
the message.
• You can set the next job during copying.
If you have more documents
If you have more documents to copy, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to scan the documents as a single set of
data.
2
Select [Next Original] while scanning is in
progress.
Note • When using the document feeder, load the
next document after the machine has finished
scanning the first document.
• When [Next Original] is displayed on the
screen shown on the right and no operation is
performed for a certain period of time, the
machine automatically assumes that there are
no more documents.
• You can change the number of copies by
selecting [Change Quantity] that is displayed
after selecting [Delete].
3
Load the next document.
<Start> button
4
Press the <Start> button.
If you have more documents, repeat steps 3 and 4.
54