Filter
Top Products
Management
SNMP
v3 users
This table lists all defined SNMP v3 users. To add a new user, click Add New User. Up to five
users are supported. To edit a user, click its link in the Username column.
Username
The SNMP v3 username.
Security
Security protocol defined for the user. Authentication type and encryption type are separated
a slash. For example, MD5/DES indicates MD5 authentication and DES encryption.
Access level
Type of access assigned to the user:
Read-only: The user has read and notify access to all MIB objects.
Read-write: The user has read, write, and notify access to all MIB objects.
Notification receivers
This table lists all defined SNMP notification receivers. SNMP notifications are sent to all
receivers in this list. To add a new receiver, click Add New Receiver. Up to five receivers
are supported. To edit a receiver, click its link in the Host column.
Host
The domain name or IP address of the SNMP notifications receiver to which the service
controller will send notifications.
UDP port
The port on which the service controller will send notifications.
Version
The SNMP version (1, 2c, 3) for which this receiver is configured.
Community/Username
For SNMP v1 and v2c, the SNMP Community name of the receiver.
For SNMP v3, the SNMP v3 Username of the receiver.
Security
Use these settings to control access to the SNMP interface.
Allowed addresses: List of IP address from which access to the SNMP interface is
permitted. To add an entry, specify the IP address and appropriate Mask, and then
select Add.
When the list is empty, access is permitted from any IP address.
Active interfaces: Enable the checkboxes that correspond to the interfaces from which
to allow access to the SNMP agent. For VLAN, GRE, or Mesh, select from the list. Use
Ctrl-click to select multiple objects.
4-12