Filter
Top Products
Network configuration
IP QoS
You configure IP quality of service (QoS) by creating IP QoS profiles that you can then
associate with VSCs or use for global wireless settings. You can configure as many as 32 IP
QoS profiles on the service controller. You can associate as many as 10 IP QoS profiles with
each VSC.
Configuration
To view and configure IP QoS profiles, select Service Controller >> Network > IP QoS.
Initially, no profiles are defined.
To create an IP QoS profile select Add New Profile.
Settings
Profile name: Specify a unique name to identify the profile.
Protocol: Specify an IP protocol to use to classify traffic by specifying its Internet
Assigned Numbers Authority (IANA) protocol number. Protocol numbers are pre-defined
for a number of common protocols. If the protocol you require does not appear in the list,
select Other and specify the appropriate number manually. You can find IANA-assigned
protocol numbers on the Internet.
Start port/ End port: Optionally specify the first and last port numbers in the range of
ports to which this IP QoS profile applies. To specify a single port, specify the same port
number for both Start port and End port. Port numbers are pre-defined for a number of
common protocols. If the protocol you require does not appear in the list, select Other
and specify the appropriate number manually.
Note To accept traffic on all ports for a specified protocol, set Start port to Other and 0. Also
set End port to 65535.
10-28