Filter
Top Products
Introduction
Safety information
Safety information
Warning Professional Installation Required
Prior to installing or using an service controller, consult with a professional installer trained
in RF installation and knowledgeable in local regulations including building and wiring codes,
safety, channel, power, indoor/outdoor restrictions, and license requirements for the
intended country. It is the responsibility of the end user to ensure that installation and use
comply with local safety and radio regulations.
Cabling: You must use the appropriate cables, and where applicable, surge protection, for
your given region. For compliance with EN55022 Class-B emissions requirements use
shielded Ethernet cables.
Country of use: In some regions, you are prompted to select the country of use during
setup. Once the country has been set, the service controller will automatically limit the
available wireless channels, ensuring compliant operation in the selected country. Entering
the incorrect country may result in illegal operation and may cause harmful interference to
other systems.
Safety: Take note of the following safety information during installation:
If your network covers an area served by more than one power distribution system, be
sure all safety grounds are securely interconnected.
Network cables may occasionally be subject to hazardous transient voltages (caused by
lightning or disturbances in the electrical power grid).
Handle exposed metal components of the network with caution.
The MSM7xx Controller and all interconnected equipment must be installed indoors
within the same building (except for outdoor models / antennas), including all PoE-
powered network connections as described by Environment A of the IEEE 802.3af
standard.
Servicing
There are no user-serviceable parts inside HP ProCurve Networking products. Any servicing,
adjustment, maintenance, or repair must be performed only by trained service personnel.
1-9