Filter
Top Products
Local mesh
Provisioning local mesh links
Provisioning is done before APs are deployed using either of the following methods:
Directly connect to each AP and use its management tool to define provisioning settings.
Connect the APs to the service controller (either directly via the LAN port or through a
local area network). After the APs are discovered, use the service controller management
tool to define provisioning settings by opening the Provisioning > Connectivity page at
either the group or AP level.
In the this example, AP 1, AP 2, and AP 4 are all provisioned with the same settings as
follows:
Use the Local mesh radio configuration table to define local mesh settings for each product
type.
Product: Indicates the product type.
Radio: Select the radio that will be used for the local mesh.
Wireless mode: Select the wireless mode that will be used for the local mesh.
13-13