Filter
Top Products
Working with public access attributes
Attribute definitions
Accounting stop only
Acct-Terminate-Cause
(32-bit unsigned integer)
Termination cause for the session See RFC 2866 for possible values. Only present when Acct-
Status-Type is Stop.
ID Cause Notes
1 User Request Supported. Indicates that the user logged out.
2 Lost Carrier Supported. Indicates that the client station is no longer
alive.
3 Lost Service Supported. When location-aware is enabled and a user
switches access points, the service controller re-
authenticates the user. If authentication fails due to
timeout, this code is returned.
4 Idle Timeout Supported. User exceeded the idle timeout value defined
for the session.
5 Session Timeout Supported. User exceeded maximum time defined for the
session.
6 Admin Reset Supported. User session was terminated by the service
controller administrator via SNMP or the management tool.
7 Admin Reboot Not Supported. (not applicable)
8 Port Error Supported. If two users are detected using the same IP
address, both are logged out with this error. Another cause
is if an error is encountered in an access list definition. For
example, an invalid host was specified.
9 NAS Error Not Supported. (not applicable)
10 NAS Request Not Supported. (not applicable)
11 NAS Reboot Supported. User was logged out because the service
controller was restarted.
12 Port Unneeded Not Supported. (not applicable)
13 Port Preempted Supported. When a user switches AP or SSID with
incompatible configurations (authentication type), they are
logged out with this code. Also if the user changes
authentication type of the same AP.
14 Port Suspended Not Supported. (not applicable)
15 Service
Unavailable
Not Supported. (not applicable)
16 Callback Not Supported. (not applicable)
9-26