Filter
Top Products
Network configuration
CDP
If at the same time Very High traffic is sent, this level immediately steals 20% from the lower
levels. In this case, 10% is taken from Normal, returning it to its minimum guaranteed level,
and 10% is taken from High.
CDP
The service controller can be configured to transmit CDP (Cisco Discovery Protocol)
information on the LAN and Internet ports. This information is used to advertise service
controller information to third-party devices, such as CDP-aware switches.
The service controller uses CDP information sent by autonomous APs to collect information
about these APs for display on the Management > Satellites page.
To enable CDP transmission, select Service Controller >> Network > CDP.
Note The service controller always listens for CDP information on the LAN and Internet ports,
even when this option is disabled, to build a list of autonomous APs. CDP information
from third-party devices and controlled APs is ignored.
Controlled APs always send CDP information.
10-18