Filter
Top Products
Network configuration
IP routes
IP routes
The routing module on the service controller provides the following features:
Compliance with RFC 1812, except for multicast routing
Supports Classless Inter Domain Routing (CIDR)
Supports Routing Internet Protocol (RIP) versions 1 and 2 in active or passive mode.
Output from the router is sent to the appropriate logical interface based on the target address
of the traffic. Supported logical interfaces include:
VLAN
Untagged
IPSec client
PPTP client
GRE tunnel.
Configuration
To view and configure IP routes, select Service Controller >> Network > IP routes.
Active routes
This table shows all active routes on the service controller. You can add routes by specifying
the appropriate parameters and then selecting Add.
The routing table is dynamic and is updated as needed. This means that during normal
operation the service controller adds routes to the table as required. You cannot delete these
system routes.
The following information is shown for each active route:
10-21