Filter
Top Products
Network configuration
Port configuration
Internet port configuration
To verify and possibly adjust Internet port configuration, select Service Controller >>
Network > Ports > Internet port.
Addressing options
The Internet port supports the following addressing options:
PPPoE client
DHCP client (default setting)
Static addressing
No address.
By default, the Internet port operates as a DHCP client. Select the addressing option that is
required by your ISP or network administrator and then select Configure. See the online
help for descriptions of all configuration options.
Link settings
By default, the service controller automatically adjusts link settings based on the type of
equipment the port is connected to. If needed, you can force the port to operate at a
particular speed or duplex setting.
Network address translation
Enable this option to permit all the computers on the network to simultaneously share the
connection on the Internet port. See Network address translation (NAT) on page 10-23.
Limit NAT port range
When enabled, the service controller reserves a range of TCP and UDP ports for each
authenticated, access-controlled user starting at port 5000, and maps all outgoing traffic for
the user within the range.
10-5