Filter
Top Products
Working with controlled APs
Configuring APs
Using menus
1. In the Network tree select the AP and then on the main menu, select Device
Management > AP management.
2. Under Access point settings, select the desired Group and select Save.
This puts the AP into the unsynchronized state (it will be displayed in orange). The move
does not occur until the AP is synchronized as described in the next section.
Synchronizing APs
Depending on the type of configuration changes that are being synchronized, wireless users
may be forced to reassociate or log in again.
After making configuration changes, you must synchronize the APs with the updated
configuration as follows:
1. In the Network tree, select the group that contains the APs, and then in the right pane,
select Discovered APs. For example, Secondary Group.
3-27