Filter
Top Products
Working with VSCs
VSC configuration options
Wireless IP filter
This option enables you to allow only wireless-to-wired LAN traffic for specific destination
addresses.
DHCP server
This option is only available if the service controller is configured as a DHCP server on the
Service Controller >> Network > Address allocation page. See Address allocation on
page 10-6.
A separate DHCP server can be enabled on each VSC to provide custom addressing to users.
This enables you to assign different IP address ranges for each VSC. To receive traffic from
users, the service controller assigns the Gateway address you specify to its LAN port.
Note These configuration options do not appear for the default VSC. The default VSC uses the
same settings as defined on the Service Controller >> Network > Address allocation
page.
DHCP relay agent
This option is only available if the service controller is currently configured as a DHCP relay
agent on the Service Controller >> Network > Address allocation page. See Address
allocation on page 10-6.
A separate DHCP relay agent can be enabled on each VSC to provide custom addressing to
users.
Note These DHCP relay agent options do not appear for the default VSC. The default VSC uses the
same settings as defined on the Service Controller >> Network > Address allocation
page.
2-20