Filter
Top Products
Working with controlled APs
Discovery of controlled APs
Diagnostic Description
Unconfigurable This AP cannot be added because the maximum number of
configured APs has been reached. To add this AP you must
first remove one or more currently configured APs.
Validating firmware The service controller is waiting for the AP to send its
software version number.
Uploading firmware The service controller is uploading new software to the AP.
Wait until the operation completes.
Installing firmware New software has been successfully uploaded to the AP.
Wait until the AP restarts to activate the new software.
Firmware failure New software failed to upload to the AP. The service
controller will retry soon.
Unsupported product No suitable software is available for this AP on the service
controller.
You should update the service controller software so that
the newly-introduced product can be recognized.
Establishing tunnel A secure management connection is being established to
the AP.
Suspicious device These AP has unexpectedly requested a new
authentication certificate from the service controller.
Possible causes are:
A previously synchronized AP was reset to factory
defaults.
An unauthorized AP may be using the same MAC
address.
This is a possible security breach that should be
investigated before authorizing the AP again.
Validating configuration The service controller is waiting for the AP to send its
configuration.
Uploading configuration Configuration settings are currently being sent to the AP.
Synchronized The AP is up and running, offers wireless services, and had
its software and configuration settings successfully
updated by the service controller.
Unsynchronized The AP is up and running and offers wireless services.
However, its configuration settings do not match the
settings defined on the service controller (at the group or
AP level).
You should Synchronize the AP.
3-15