Filter
Top Products
Authentication services
Using the integrated RADIUS server
Accounting UDP port
Indicates the port the service controller uses for accounting. This port is always set to the
standard value of 1813.
Server authentication support
Select the authentication protocols that the internal RADIUS server will support:
PAP: This protocol must be enabled if any VSCs are configured to use MAC-based
authentication or HTML authentication.
EAP-TTLS
EAP-PEAP
EAP-TLS
RADIUS authorization
Note Applies to autonomous and third-party APs. Requests from controlled APs are always
accepted because they use the management tunnel.
Enable this option to restrict access to the RADIUS server. The RADIUS server will only
respond to requests from RADIUS clients that appear in the list, or that match the default
shared secret, as described below.
IP address
Specify the IP address of the RADIUS client.
Mask
Specify the network mask.
Shared secret
Specify the secret (password) that RADIUS client must use to communicate with the RADIUS
server.
Default shared secret
Note Applies to autonomous APs only. Requests from controlled APs are always accepted because
they use the management tunnel.
Enable this option to set a shared secret to safeguard communications between the internal
RADIUS server and clients not in the RADIUS authorization list.
Shared secret/Confirm shared secret
Specify the secret (password) that service controller will use when communicating with
RADIUS clients that do not appear in the RADIUS authorization list. The shared secret must
match on both the clients and the service controller.
User account configuration
User accounts for the internal RADIUS server are defined using the Service Controller >>
Users menu. See Chapter 7: User authentication.
6-4