Filter
Top Products
This command may be used to allow you to monitor the status of the crucial
ports on your network while the alerts from the other ports are disabled.
•
Set optical power
Each port on this module can be set to operate at high or normal power.
When operating at high power mode, the fiber distance between the two
modules and the module or the transceiver can be as far as 4000 meters.
Please note that you must enable high power mode at both ends to achieve
the maximum possible distance. To set the power mode, you can use the
following management command:
SET PORT {slot.port} HIGH_POWER {enable|disable}
7.10 8260 Ethernet Modules Summary
The following table provides a summary of the functions supported by the 8260
Ethernet modules.
Table 25. 8260 Ethernet Modules Summary
Module 24-Port 10Base-T 10-Port
10Base-FB
20-Port 10Base-T 40-Port 10Base-T
Feature Code 1024 1110, 1210, 1610 1020 1040
Daughter Cards
Supported
1 1 2 2
I/O Modules N/A N/A N/A N/A
Number of Ports 24 10 20 40
Type of Ports Telco ST, FC, SMA RJ-45 RJ-45
Switching
Supported
Port Port Port Port
Number of Slots
Used
1 1 1 2
Number
Backplane
Networks
Accessible
8 8 8 8
Number of
Isolated Networks
Accessible
8 4 8 8
Number of
Segments
Supported
Simultaneously
Any Combination
of 6
Any Combination Any Combination
of 8
Any Combination
of 8
Cabling
Supported
UTP Cat 3 and
Above
Multi-mode Fiber UTP & STP UTP & STP
Security Card
Support
Yes - Not on
Isolated Networks
Yes - Not on
Isolated Networks
Yes - Not on
Isolated Networks
Yes - Not on
Isolated Networks
Port Redundancy Yes Yes Yes Yes
Network Statistics
Supported
Without
Monitoring Card
No No Repeater MIB Repeater MIB
Other Notes Fiber supported -
50/125, 62.5/125,
85/125, 100/140
120 8260 Multiprotocol Intelligent Switching Hub