Filter
Top Products
Config * OSPF Static Convert Table Module: BladeRunner
System Page 1 Time: 17:48 11 Jan 95
IP Address IP Mask TOS Hop Metric
Modify Entry Prev Page Next Page Exit
Return to the previous screen
Figure 181. LMS Configuration Panel
This panel allows you to enter the following parameters for each entry:
•
IP Address
This parameter specifies the destination IP address.
•
IP Mask
This parameter specifies the destination IP address mask.
•
TOS
This parameter specifies the Type Of Service for this route.
•
Hop Count
This parameter specifies hop count for this static route.
•
Metric
This parameter specifies the metric in OSPF converted from static route.
14. If you have not defined the conversion information for an imported static
route, the
Static Default Conversion Table
will be used. This table is set with
a number of default entries when the Multiprotocol Interconnect module is
shipped. You can view and/or modify the contents of this table by selecting
OSPF Static Default Convert Table
from the
OSPF Menu
panel. The resulting
display is shown in Figure 182 on page 304.
Chapter 11. 8260 Multiprotocol Interconnect Module 303