Filter
Top Products
Config * OSPF Virtual Interface Table Module: BladeRunner
System Page 1 Time: 17:44 11 Jan 95
Area ID Neighbor TransDelay RetransInt HelloInt RtrDeadInt
Add Entry Prev Page Next Page Exit
Return to the previous screen
Figure 175. LMS OSPF Virtual Interface Table Panel
The following parameters can be specified for each entry:
•
Area ID
This parameter specifies the 32-bit integer identifying the transit area
that the virtual link traverses. By definition, this is not 0.0.0.0 (the
backbone).
•
Neighbor
This parameter specifies the router ID of the virtual neighbor.
•
TransDelay
This parameter specifies the number of seconds it takes to transmit a
link-state update packet over this interface.
•
RetransiInt
This parameter specifies the length of time (in seconds) between
link-state advertisement retransmissions for adjacencies belonging to
this interface. This value is also used when retransmitting database
descriptions and link-state request packets.
•
HelloInt
This parameter specifies the length of time (in seconds) between Hello
packets that the router sends on this interface. This parameter must be
the same for the virtual neighbor.
•
RtrDeadInt
This parameter specifies the length of time (in seconds) that a router′s
Hello packet will not have been seen before its neighbor declares the
router down. This should be some multiple of the Hello interval and
must be the same for the virtual neighbor.
Chapter 11. 8260 Multiprotocol Interconnect Module 297