Filter
Top Products
Once the terminal has been configured press the Enter key. If the terminal has
been configured correctly the following message should be displayed:
Table 10 (Page 2 of 2). DMM Terminal Defaults and Options
Parameter Factory
Default
Options
Stop Bits 1 1 or 2
8260A
Distributed Management Module (v2.10-H)
Login:
Figure 17. DMM Login Message
To log in as
superuser
at the
Login
prompt type in
system
and press the Enter
key. The module is shipped from the factory with a null password, so at the
Password
prompt press Enter.
At this stage you are logged into the 8260 with full access to all commands.
4.2.4.1 Configuring DMM Users
Three types of users can be used to access DMM:
•
User
This type of user can view the configuration of the 8260 and all the installed
modules and daughter cards. Additionally, this user can obtain statistics
about the various components of the network.
•
Administrator
This type of user can perform all the user functions. Additionally, this user
can modify the configuration of the hub and all the installed modules and
daughter cards.
•
Superuser
This type of user can perform all the functions of the administrator.
Additionally, this user can create new users and perform maintenance
functions such as downloading new software to the DMM and other modules.
The DMM is shipped from the factory with a single user defined. This user is
called
system
and has superuser access. Also, it does not have any password
assigned to it.
After logging in to DMM for the first time, it is strongly advised that for security
reasons you change the password for the superuser using the example given in
Figure 18 on page 45.
44 8260 Multiprotocol Intelligent Switching Hub