Filter
Top Products
The format of the command to display the contents of the control table
for the statistics group is slightly different. In this case, you must use the
following command:
SHOW RMON statistics ETHERNET CONTROL ALL
The following example allows you to determine all the interfaces on
which the RMON host group is enabled.
8260A> show rmon host control all
RMON Host Control Information:
Index Data Source Table Size Last Delete Time Owner
----- --------------- ----------- ------------------- ----------------
1 Interface 3 10 No Deletions system
8260A>
Figure 122. RMON Host Control Table
As can be seen, at the time of display, the host group is only enabled on
interface 3.
•
Once the DMM interface is added to the appropriate RMON control table,
the RMON information for that group will be collected on the network to
which this interface is attached. You can display the contents of the
RMON information for the desired group using the following command:
SHOW RMON {rmon group} DATA {control_index} {data_index}
In the above command, the control_index is the index for the RMON
group that you want to display the information for. You can determine
the control_index by displaying the RMON control table as shown in
Figure 122. The data_index is the index of the specific collected
information that you want to view. For more information about the
values for data_index for various groups, please refer to the
DMM
Command Guide,
SA33-0275.
An example of how to display the RMON Host group output is shown in
Figure 123 on page 222.
Chapter 10. 8260 RMON Support 221