Filter
Top Products
Config * IP Security Access List Module: BladeRunner
Page 1 Time: 12:07 18 Jan 95
List Transmit Action on Receive Action on ICMP
No. Check No Match (Tx) Check No Match (Rx) Generation
1 Enabled pass Enabled pass Enabled
2 Disabled pass Disabled pass Disabled
3 Disabled pass Disabled pass Disabled
4 Disabled pass Disabled pass Disabled
5 Disabled pass Disabled pass Disabled
6 Disabled pass Disabled pass Disabled
7 Disabled pass Disabled pass Disabled
8 Disabled pass Disabled pass Disabled
9 Disabled pass Disabled pass Disabled
10 Disabled pass Disabled pass Disabled
11 Disabled pass Disabled pass Disabled
12 Disabled pass Disabled pass Disabled
Modify Entry Prev Page Next Page Exit
Modify an entry in the IP Security List
Figure 184. LMS IP Security Access Panel
This panel allows you to define the following parameters for each entry:
•
List No.
This field identifies a security table. It corresponds with the
List No
displayed on the upper left hand corner of the security table.
•
Transmit Check
This parameter determines whether IP datagrams to be transmitted on
the interface are checked to see if they match the entries in the security
table.
•
Action on No Match
This parameter specifies whether to allow an IP datagram that does not
match the criteria defined in the corresponding Security table to be
forwarded to its destination (pass) or to be discarded (block). If two
tables are assigned to the same port and the Action on No Match
parameters are not the same, the values configured for Security Access
List 2 take precedence.
•
Receive Check
This parameter determines whether IP datagrams received on the
interface are checked to see if they match the entries in the Security
table.
•
Action on No Match
This parameter specifies whether to allow an IP datagram that does not
match the criteria defined in the corresponding security table to be
forwarded to its destination (pass) or to be discarded (block). If two
tables are assigned to the same port and the Action on No Match
parameter are not the same, the values configured for the security
access list 2 takes precedence.
Chapter 11. 8260 Multiprotocol Interconnect Module 307