Filter
Top Products
Config * Custom Filter Statement Table Module: BladeRunner
Log. Port: 1 LOGICAL PORT Page 1 Time: 14:10 9 Jan 95
Statement ID Test Name Action on Success Action on Failure
1 Frame Type Test Stmt 2 Discard
2 ″″ Discard Discard
3 ″″ Discard Discard
4 ″″ Discard Discard
5 ″″ Discard Discard
6 ″″ Discard Discard
7 ″″ Discard Discard
8 ″″ Discard Discard
9 ″″ Discard Discard
10 ″″ Discard Discard
Modify Entry Prev Page Next Page Prev Port Next Port Exit
Return to the previous screen
Figure 159. LMS Custom Filter Statement Table
The port to which the table applies is displayed on the top left hand corner of
the screen. You can use the
Prev Port
and
Next Port
options on the Menu
Bar to select the required port.
This table allows you to apply up to 16 tests on the frames received on each
port.
To configure a new entry in the table, you must select
Modify Entry
and type
the entry′s
Statement ID
. Once you have entered the information for the
entry, you must select Set Entry and press Enter to confirm or select
Cancel
to abandon the operation. The following parameters can be specified for
each entry in the Custom Filter Statement Table:
•
ID Number
This is the number assigned to the selected test in the
Custom Filter Test
Table
.
•
Test Name
:
This is the name assigned to the selected test in the
Custom Filter Test
Table
.
•
Action on Success
This parameter specifies the action to be taken by the Multiprotocol
Interconnect module when the test is successful.
•
Action on Failure
This parameter specifies the action to be taken by the Multiprotocol
Interconnect module when the test is unsuccessful.
For both the
Action on Success
and
Action on Failure
, the following
values can be specified:
− Discard: Discard the frame
Chapter 11. 8260 Multiprotocol Interconnect Module 277