Filter
Top Products
Note
If you select
Start BOOTP Download
and do not specify the TFTP server
IP address and TFTP filename in the above panel, the Multiprotocol
Interconnect module will use BOOTP to locate a BOOTP server in the
network in order to get this information to perform the download
operation.
To perform download from a PC attached to the Multiprotocol Interconnect
module′s serial port, select
Start Serial Download
.
Config * Download Parameters Module: BladeRunner
System Time: 15:26 5 Jan 95
TFTP Server: 9.67.46.45 TFTP Status: idle
TFTP Filename: bld.op
Start Serial Download Start BootP Download Exit
Figure 144. LMS Download Parameters Panel
11.8.2 Configuring Port Parameters
To configure the ports on the Multiprotocol Interconnect module, you must select
Port Menu
from the
Configuration Menu
. The panel shown in Figure 145 on
page 256 will be displayed.
Chapter 11. 8260 Multiprotocol Interconnect Module 255