Filter
Top Products
Config * OSPF Rip Convert Table Module: BladeRunner
System Page 1 Time: 17:46 11 Jan 95
IP Address IP Mask Hop Count Metric
9.67.46.0 255.255.255.240 1 10
9.67.46.0 255.255.255.240 2 20
9.67.46.0 255.255.255.240 3 30
9.67.46.0 255.255.255.240 4 40
9.67.46.0 255.255.255.240 5 50
9.67.46.0 255.255.255.240 6 60
9.67.46.0 255.255.255.240 7 70
9.67.46.0 255.255.255.240 8 80
9.67.46.0 255.255.255.240 9 90
9.67.46.0 255.255.255.240 10 100
Modify Entry Prev Page Next Page Exit
Return to the previous screen
Figure 178. LMS Configuration Panel
This panel allows you to enter the following parameters for each entry:
•
IP Address
This parameter specifies the destination IP address found by RIP.
•
IP Mask
This parameter specifies the destination IP address mask.
•
Hop Count
This parameter specifies hop count measured in RIP.
•
Metric
This parameter specifies the metric in OSPF converted from RIP.
11. If you have not defined the conversion information for an imported RIP entry,
the
RIP Default Conversion Table
will be used. This table is set with a
number of default entries when the Multiprotocol Interconnect module is
shipped. You can view and/or modify the contents of this table by selecting
OSPF RIP Default Convert Table
from the
OSPF Menu
panel. The resulting
display is shown in Figure 179 on page 301.
300 8260 Multiprotocol Intelligent Switching Hub