Filter
Top Products
•
Configuration Menu
This option allows you to alter configuration parameters and monitor
statistics about the Multiprotocol Interconnect module.
•
Status Menu
This option allows you to review the statistics and configuration information
without changing any values.
•
Enable/Disable Write Access
When you first access the LMS, you automatically have read-only access to
monitor the Multiprotocol Interconnect module. Write permission is
protected by a password. If you want to modify configuration parameters,
you must select
Enable Write Access
from the menu and enter the correct
password. Alternatively, you may press CTRL-W from any menu to toggle
write permission
On
or
Off
(an * will appear on the left of the screen title
when you have write permission).
The Multiprotocol Interconnect module is shipped from the factory with no
password. This can be changed by using
Change Password
from the
System
Parameters Screen
as discussed in 11.8.1, “Configuring System Wide
Parameters” on page 252.
Note: There can be only one user with write access at any one time.
Therefore, if another user has accessed the Multiprotocol Interconnect
module and has enabled write access, you will be unable to enable write
access. There can be a total of four users accessing the LMS
simultaneously.
•
Help
This option provides you with the list of shortcut commands which you can
use to navigate through the LMS screens. The short cut commands are
shown in Figure 139 on page 249.
248 8260 Multiprotocol Intelligent Switching Hub