Filter
Top Products
11.8.8.1 Configuring for OSPF
To configure the Multiprotocol Interconnect module to use OSPF, you must select
OSPF
from the
Protocols Menu
. The resulting panel is shown in Figure 168.
Config * OSPF Menu Module: BladeRunner
Time: 11:11 11 Jan 95
OSPF System Parameters
OSPF Area Table
OSPF Area Default Metric Table
OSPF Address Range Table
OSPF Host Table
OSPF Interface Table
OSPF Interface Metric Table
OSPF Virtual Interface Table
OSPF Neighbor Table
OSPF RIP Filter Table
OSPF RIP Convert Table
OSPF RIP Default Convert Table
OSPF Static Filter Table
OSPF Static Convert Table
OSPF Static Default Convert Table
Exit
Enter the OSPF system parameters screen
Figure 168. LMS OSPF Menu Panel
This menu panel allows you to access all the panels related to viewing and
configuring OSPF parameters for the Multiprotocol Interconnect module. The
following steps should be taken to configure the various parameters required by
OSPF:
1. Configure the system-wide OSPF parameters by selecting
OSPF System
Parameters
from the
OSPF Menu
. An example of the OSPF System
Parameters panel is shown in Figure 169 on page 289.
288 8260 Multiprotocol Intelligent Switching Hub