Filter
Top Products
Config * Jump Table - Config screens Module: BladeRunner
Time: 14:25 5 Jan 95
System Download Trap Dest. Table Physical Port List
Phy. Port Protocol Phy. Port Interface Logical Port Logical Port MLink
Bridging System Bridging Port STP System STP Port
Filtering Database Custom Filter Test Custom Filter Stmt. Src. Routing System
Conversion System IP System IP Port IP Port Address
IP NetToMedia Table IP Forwarding IP Security List IP Security Table
IP BootHelper IP Ping DECnet System DECnet Port
DECnet Area Routing DECnet Routing DECnet Sec. List DECnet Sec. Table
IPX System IPX Port IPX Routing IPX SAP Bindery
IPX Security List IPX Security Table OSPF System OSPF Area Table
OSPF Area Def. Met. OSPF Address Range OSPF Host OSPF Interface
OSPF IF Metric OSPF Virtual IF OSPF Neighbor OSPF RIP Filter
OSPF RIP Convert OSPF RIP Def. Conv. OSPF Static Filter OSPF Static Convert
OSPF St. Def. Conv.
Status Screens Exit
Return to the previous screen
Figure 140. LMS Jump Table
•
Close Connection
:
This option will only be displayed if you have accessed the Multiprotocol
Interconnect module using Telnet. In that case, this option allows you to
close the connection when required.
11.7 SNMP Support
The Multiprotocol Interconnect module provides an SNMP agent which can be
used to manage the Multiprotocol Interconnect module via an SNMP manager.
To access the SNMP agent, the SNMP manager is required to provide the
correct
community name
as defined in the Multiprotocol Interconnect module.
The process of defining community names for the Multiprotocol Interconnect
module is described in 11.8.1, “Configuring System Wide Parameters” on
page 252.
Depending on the community name settings, the SNMP agent may support any
of the following options for an SNMP manager:
•
Get-request
•
Get-next-request
•
Set-request
•
Get-response
•
Trap
The following MIBs are supported by the SNMP agent:
•
MIB-II
•
Dot1dBridge Group
250 8260 Multiprotocol Intelligent Switching Hub