Filter
Top Products
11.8.2.3 Configuring Logical Port Parameters
This panel allows you to configure parameters for Ethernet, token-ring and WAN
logical ports. An example of this panel for an Ethernet port is shown in
Figure 149.
Config * Logical Port Parameters Module: BladeRunner
Log. Port: 1 LOGICAL PORT Time: 16:08 5 Jan 95
Attached Physical Port Channel:
10
Encapsulation: csmaLan
Logical Port Name: LOGICAL PORT Admin Status: up
Partner Type: other
Attach Port Detach Port
Search Port Prev Port Next Port Exit
Return to the previous screen
Figure 149. LMS Logical Port Panel
This panel allows you to enter/display the following parameters:
•
Attached Physical Port
This is a read-only parameter and identifies the physical port to which this
entry applies.
In the case of LAN logical ports, they will be created automatically and will
be attached to a physical port with the same port ID. For example, logical
port 1 will be attached to physical port 1, etc.
•
Channel
This parameter does not apply to LAN ports.
•
Logical Port Name
This parameter can be used to configure a unique name for the selected
logical port.
•
Admin Status
This parameter shows the desired status of the logical port.
Up
means that
the port is configured and can receive or transmit frames. When the status
is
Down
, the port is configured but cannot send or receive frames.
•
Partner Type
This parameter specifies the type of partner that this logical port is
connected to. On LAN ports, this parameter is set to
other
and cannot be
changed.
260 8260 Multiprotocol Intelligent Switching Hub