Filter
Top Products
Config * IP Net To Media Table Module: BladeRunner
System Page 1 Time: 10:50 11 Jan 95
Port Network Address Media Address Type
1 9.67.46.13 400000000001 static
1 9.67.46.33 10005A7903C7 dynamic
1 9.67.46.34 10005A7903E1 dynamic
1 9.67.46.40 0000B528023E dynamic
1 9.67.46.41 08008F3003EF dynamic
1 9.67.46.46 08005A13396F dynamic
Add Entry Search Addr Prev Page Next Page Exit
Add a new entry to the IP Net To Media Table
Figure 166. LMS IP Net To Media Table
This table can be used to view and/or modify the contents of the ARP table.
Each entry in this table contains the following parameters:
•
Network Address
This parameter specifies the IP address of the station that this entry
applies to.
•
Physical Address
This parameter specifies the MAC address of the station that this entry
applies to.
•
Type
This field is a read-only field and indicates that the address mapping has
been learned through ARP (dynamic) or configured by the user (static).
To add a static entry to the ARP table, select
Add Entry
from this panel. A
pop-up menu will be displayed which allows you to enter the IP address and
the corresponding MAC address. Once, you have specified this information
select
Set Entry
to add the entry to the ARP table or
Cancel
to abandon the
operation.
9. If you are planning to use the BOOTP protocol between a BOOTP server and
client and the BOOTP client is connected to the BOOTP server via the
Multiprotocol Interconnect module, you must configure your module as a
Boothelper
.
BOOTP allows a client to request the following from a BOOTP server:
•
Client′s own IP address
•
IP address of a TFTP server
•
Name of the code image file
286 8260 Multiprotocol Intelligent Switching Hub