Filter
Top Products
•
ICMP Generation
This field specifies whether an ICMP Destination Unreachable message
is forwarded to the source address on any IP datagram that is discarded
because of security checks.
Note: There is only one IP security access list per Multiprotocol Interconnect
module.
IP security access list may contain up to 32 entries.
3. Enable IP security on the module, using the
IP System Parameters
panel.
4. Specify up to two IP security lists for each IP port using the
IP Port
Parameters
panel.
Note: A single IP security table may be active on any number of ports at the
same time.
11.8.10 Configuring for IPX Routing
The Multiprotocol Interconnect module allows you to configure it as an IPX
router. To do so, you must perform the following steps:
1. Configure the system-wide parameters for the Multiprotocol Interconnect
module as described in 11.8.1, “Configuring System Wide Parameters” on
page 252.
2. Configure the port parameters for the Multiprotocol Interconnect module′s
ports as described in 11.8.2, “Configuring Port Parameters” on page 255.
3. Select
IPX
from the
Protocols Menu
. A panel as shown in Figure 185 will be
displayed.
Config * IPX Menu Module: BladeRunner
Time: 10:49 13 Jan 95
IPX System Parameters
IPX Port Parameters
IPX Routing Table
IPX SAP Bindery Table
IPX Security Access List
IPX Security Table
Exit
Enter the IPX system parameters screen
Figure 185. LMS IPX Menu Panel
This panel allows you to access all the panels for viewing and configuring
the IPX parameters supported by the Multiprotocol Interconnect module.
308 8260 Multiprotocol Intelligent Switching Hub