Filter
Top Products
This parameter determines if the RIP filter table will be used for
importing routes found by RIP. RIP filter table is discussed later in this
section.
•
Import Static Routes
This parameter determines if the static route filter table will be used for
importing static routes. Static route filter table is discussed later in this
section.
•
Default Action on No Match for RIP Routes
This parameter specifies the action to be taken when a RIP route does
not match any entry in the RIP filter table. If this parameter is set to
import
, a route found by RIP that does not have a match in the RIP filter
table is imported using the default hop-to-metric conversion table.
Otherwise, it is not imported. Hop-to-metric conversion table is
explained later in this section.
•
Default Action on No Match for Static Routes
This parameter specifies the action to be taken when a static route does
not match any entry in the static route filter table. If this parameter is set
to
import
, a static route that does not have a match in the static route
filter table is imported using the default hop-to-metric conversion table.
Otherwise, it is not imported.
2. Define the interfaces that are enabled for OSPF. To do so, you must select
OSPF Interface Table
from the
OSPF Menu
. An example of the resulting
panel is shown in Figure 170.
Config * OSPF Interface Table Module: BladeRunner
System Page 1 Time: 17:40 11 Jan 95
IP Address Port Area ID Type AdminStat Priority PollInt
9.67.46.17 0 0.0.0.0 broadcast Disabled 1 120
9.67.46.44 0 0.0.0.0 broadcast Enabled 1 120
9.67.46.94 0 0.0.0.0 broadcast Disabled 1 120
Modify Entry Prev Page Next Page Exit
Return to the previous screen
Figure 170. LMS OSPF Interface Table Panel
This table allows you to specify the OSPF-specific information about the
interfaces. Note that you cannot create or delete entries on this table. They
290 8260 Multiprotocol Intelligent Switching Hub