Filter
Top Products
Chapter 2 - Defining Standard Audio Only Conferences and Reservations
2-70
Listing Participants
You can view the updated list of participants in the On Going Conference list,
in the Browser, Status and Monitor panes.
• If Dial-Out Manually was selected in the Conference Properties dialog
box, participants remain disconnected (Stand By state) until the operator
initiates the connection from the MCU to the participant. Until all
participants connect to conference, the conference shows the “Not Full”
status.
• If Dial-out Manually was not selected for the conference, the system
automatically dials out to all listed participants and connects them to the
conference.
• Defined, dial-in participants status is “Waiting for dial-in” until they
connect to the conference.
Disconnected participant
Recording port
Connected participant