Filter
Top Products
114 Advanced iDRAC6 Configuration
Enabling and Disabling the RACADM Remote
Capability
NOTE: It is recommended that you run these commands on your local system.
The RACADM remote capability is enabled by default. If disabled, type the
following
RACADM command to enable:
racadm config -g cfgRacTuning -o
cfgRacTuneRemoteRacadmEnable 1
To disable the remote capability, type:
racadm config -g cfgRacTuning -o
cfgRacTuneRemoteRacadmEnable 0
RACADM Subcommands
Table 5-15 provides a description of each RACADM subcommand that you
can run in RACADM. For a detailed listing of RACADM subcommands,
including syntax and valid entries, see the iDRAC6 Administrator Reference
Guide available on the Dell Support website at support.dell.com/manuals.
When entering a RACADM subcommand, prefix the command with
racadm, for example:
racadm help
-S Specifies that RACADM should check for invalid
certificate errors. RACADM stops the execution of the
command with an error message if it detects an invalid
certificate.
Table 5-14. racadm Command Options
(continued)
Option Description