Filter
Top Products
252 Configuring Intelligent Platform Management Interface
NOTE: SOL can be enabled or disabled for each individual user.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgUserAdmin -o
cfgUserAdminSolEnable -i
<id>
2
where
<id>
is the user’s unique ID.
4
Configure IPMI Serial.
a
Change the IPMI serial connection mode to the appropriate setting.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgSerial -o
cfgSerialConsoleEnable 0
b
Set the IPMI Serial baud rate.
Open a command prompt, type the following command, and press
<Enter>:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialBaudRate
<baud_rate>
where
<baud_rate>
is 9600, 19200, 57600, or 115200 bps.
For example:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialBaudRate 57600
c
Enable the IPMI serial hardware flow control.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialFlowControl 1