Filter
Top Products
Using the iDRAC6 Configuration Utility 307
Virtual Media Configuration
Virtual Media
Press <Enter> to select Detached, Attached, or Auto-Attached. When you
select Attached, the Virtual Media devices are attached to the USB bus,
making them available for use during Virtual Console sessions.
If you select Detached, users cannot access Virtual Media devices during
Virtual Console sessions.
NOTE: To use a USB Flash Drive with the Virtual Media feature, the USB Flash
Drive Emulation Type must be set to Hard disk in the BIOS Setup Utility. The BIOS
Setup Utility is accessed by pressing <F2> during server start-up. If the USB Flash
Drive Emulation Type is set to Auto, the Flash Drive will appear as a floppy drive to
the system.
DNS Servers from
DHCP
Select On to retrieve DNS server addresses from a DHCP
service on the network. Select Off to specify the DNS server
addresses below.
DNS Server 1 If DNS Servers from DHCP is Off, enter the IP address of the
first DNS server.
DNS Server 2 If DNS Servers from DHCP is Off, enter the IP address of the
first DNS server.
Advanced LAN
Configurations
Auto-Negotiate If NIC Selection is set to Dedicated, select between Enabled
and Disabled.
When Enabled is selected, LAN Speed Setting and LAN
Duplex Setting are configured automatically.
LAN Speed Setting If Auto-Negotiate is set to Disabled, select between 10 Mbps
and 100 Mbps.
LAN Duplex Setting If Auto-Negotiate is set to Disabled, select between Half
Duplex and Full Duplex.
Table 17-1. LAN Parameters
(continued)
Item Description