Filter
Top Products
Using the iDRAC6 Directory Service 175
NOTE: At least one of the 3 addresses is required to be configured. iDRAC6
attempts to connect to each of the configured addresses one-by-one until it
makes a successful connection. With Standard Schema, these are the
addresses of the domain controllers where the user accounts and the role
groups are located.
If you want to use DNS lookup to obtain the Active Directory Domain
Controller server address, type the following command:
racadm config -g cfgActiveDirectory -o
cfgADDcSRVLookupEnable=1
• To perform the DNS lookup with the domain name of the login user:
racadm config -g cfgActiveDirectory -o
cfgADDcSRVLookupbyUserdomain=1
• To specify the domain name to use on the DNS lookup:
racadm config -g cfgActiveDirectory -o
cfgADDcSRVLookupDomainName <domain name to use
on the DNS lookup>
To specify the Global Catalog server address, type the following command:
racadm config -g cfgActiveDirectory -o cfgADGlobal
Catalog1 <fully qualified domain name or IP
address of the domain controller>
racadm config -g cfgActiveDirectory -o cfgADGlobal
Catalog2 <fully qualified domain name or IP
address of the domain controller>
racadm config -g cfgActiveDirectory -o cfgADGlobal
Catalog3 <fully qualified domain name or IP
address of the domain controller>
NOTE: The Global Catalog server is only required for standard schema in the
case that the user accounts and the role groups are in different domains. And,
in this multiple domain case, only the Universal Group can be used.
NOTE: The FQDN or IP address that you specify in this field should match the
Subject or Subject Alternative Name field of your domain controller certificate
if you have certificate validation enabled.
If you want to use DNS lookup to obtain the Active Directory Global
Catalog server address, type the following command: