Filter
Top Products
Configuring vFlash SD Card and Managing vFlash Partitions 273
Enabling or Disabling the vFlash or Standard SD Card
Open a telnet/SSH/Serial console to the server, log in, and enter the following
commands:
• To enable vFlash or standard SD card:
racadm config -g cfgvFlashsd -o cfgvflashSDEnable
1
• To disable vFlash or standard SD card:
racadm config -g cfgvFlashsd -o cfgvflashSDEnable
0
NOTE: The RACADM command functions only if a vFlash or standard SD card is
present. If a card is not present, the following message is displayed:
ERROR: SD
Card not present
.
Initializing the vFlash or Standard SD Card
Open a telnet/SSH/Serial console to the server, log in, and enter the following
command to initialize the card:
racadm vflashsd initialize
All existing partitions are deleted and the card is reset.
Getting the Last Status on the vFlash or Standard SD Card
Open a telnet/SSH/Serial console to the server, log in, and enter the following
command to get the status of the last initialize command sent to the vFlash
or standard SD card:
racadm vFlashsd status
NOTE: This command only shows the status of commands sent to the SD card. To
get the status of commands sent to individual partitions on the SD card use the
command:
racadm vflashpartition status
Resetting the vFlash or Standard SD Card
Open a telnet/SSH/Serial console to the server, log in, and enter:
racadm vflashsd initialize