Filter
Top Products
36 Basic Installation of the iDRAC6
Software Installation and Configuration Overview
This section provides a high-level overview of the iDRAC6 software
installation and configuration process. For more information on the iDRAC6
software components, see "Installing the Software on the Managed System"
on page 37.
Installing iDRAC6 Software
To install iDRAC6 software:
1
Install the iDRAC6 software on the managed system. See
"Installing the
Software on the Managed System
" on page 37.
2
Install the iDRAC6 software on the management station. See "Installing
the Software on the Management Station" on page 37.
Configuring iDRAC6
To configure iDRAC6:
1
Use one of the following configuration tools:
• Web-based interface (see "Configuring the iDRAC6 Using the Web
Interface" on page 45)
• RACADM CLI (see
iDRAC6 Administrator Reference Guide
available
at
support.dell.com/manuals
)
• Telnet console (see "Using a Telnet Console" on page 89)
NOTE: Using more than one iDRAC6 configuration tool at the same time may
generate unexpected results.
2
Configure the iDRAC6 network settings. See "Configuring the iDRAC6
Network Settings" on page 109.
3
Add and configure iDRAC6 users. See "Adding and Configuring
iDRAC6 Users" on page 129.
4
Configure the Web browser to access the Web-based interface. See
"Configuring a Supported Web Browser" on page 41.
5
Disable the Microsoft Windows Automatic Reboot Option. See "Disabling
the Windows Automatic Reboot Option" on page 316.
6
Update the iDRAC6 Firmware. See "Updating the iDRAC6 Firmware" on
page 39.