Filter
Top Products
84 Configuring the iDRAC6 Using the Web Interface
•
–l
<image_location>
; image location on the network share; use
double quotes around the location
•
–s
; display current status
NOTE: The maximum number of characters supported for User Name and
Password is 40 and for Image File Path it is 511. All characters including
alphanumeric and special characters are allowed for these three fields except the
following characters:
• ' (single quote)
• " (double quote)
• , (comma)
• < (less than)
• > (greater than)
Internal Dual SD Module
The Internal Dual SD Module (IDSDM) provides redundancy on the
hypervisor SD card by using another SD card that mirrors the first SD card
content. The second SD card can be set to IDSDM along with the other SD
card by setting the Redundancy option to Mirror mode in the Integrated
Devices screen of the system BIOS setup. For more information about the
BIOS options for IDSDM, see the Hardware Owner’s Manual available on the
Dell Support website at support.dell.com/manuals.
NOTE: In the BIOS setup, Integrated Devices screen, the Internal USB Port option
must be set to On. If this is set to Off, the IDSDM is not visible to the system as a
boot device.
One of the two SD cards can be the master. For example, if two SD cards are
installed in the IDSDM while AC power is removed from the system, SD1 is
considered the active or master card. SD2 is the backup card, and all file
system IDSDM writes will go to both cards, but reads will occur only from
SD1. At any time if SD1 fails or is removed, SD2 will automatically become
the active (master) card. The vFlash SD card is disabled in Mirror Mode.