Filter
Top Products
Hardware redundancy lost
An error occurred in redundant (back-up or duplicate) hardware. This
function continues to operate, but service is required. A second failure in
this hardware results in a loss of the function.
Informational
Indicates that an event of importance occurred that was not an error.
LIC An error occurred due to a Licensed Internal Code problem.
Machine check
Either an error occurred that caused the system not to operate, or an SRC
was present on the control panel when the system was re-IPLed (from a
function 03 or a programmed IPL). These errors are logged during the next
IPL if the system was not powered off. They are logged with the data that
was displayed in control panel functions 11 through 19 at the time you
performed another IPL on the system.
Predictive analysis
Indicates that a system component detected a condition that might cause a
problem, if it is not corrected.
Permanent
An error that could not be recovered.
Qualified
An error occurred that is described (qualified) more in the Description field.
See the Problem Analysis information for your system or the device service
information for a complete listing of reference codes.
Recoverable
An error occurred, and the condition was recovered either automatically or
through user intervention (printer out of forms, for example).
Remote
Indicates buffered errors from remote devices or input/output processors.
Software
An error occurred due to a software problem.
Statistic
Indicates that this entry contains statistical information (for example, the
number of bytes that were read or written).
Temporary
A previously-detected error condition was no longer present when the
operation was retried (a successful additional attempt occurred).
Threshold
Indicates that the system reached a service action point. The occurrence of
temporary errors was more than the limit specified for that type of error
condition.
Vary on
Indicates that a vary-on operation occurred.
System reference code
The system reference code identifies a unique logging condition. The system
reference code field consists of a four-character hardware or software table ID,
followed by a four-character unit reference code.
Chapter 3. Product Activity Log 113