Filter
Top Products
Work with Hardware Products (WRKHDWPRD) Command
Introduction
The Work with Hardware Products (WRKHDWPRD) command allows you to
work with description labels. The system uses description labels to identify
hardware.
When you run the WRKHDWPRD command, the Work with Hardware Products
display appears with the following options:
1. Display description label locations
This option allows you to display or print the current configuration label
location information. It is the customer’s responsibility to configure and assign
labels in the system for cables and devices. Before a system upgrade procedure,
the service representative uses this option to identify cables and devices that
might need a (physical) label attached.
For more information on how to use this option before an upgrade, see “Using
the configuration description label information to prepare for a system
upgrade”.
2. Change description label locations
This option allows you to display, change, or print a worksheet of the current
configuration label location information. Use this option after a system upgrade
to compare the system configuration description label information with the
(physical) label that is attached to the cable or device. If the labels do not
match, use the Change Description Label Locations display to change the system
label.
For more details on how to use this option after an upgrade, see “Using the
configuration description label information after a system upgrade” on
page 304.
Using the configuration description label information to prepare
for a system upgrade
Before powering the system down for an upgrade, you must record specific system
value information, verify the system configuration, and create (physical) labels to
attach to the system cables and devices.
Work With Hardware Products
System: xxx
Select one of the following:
4. Display description label locations
5. Change description label locations
Selection
__
F3=Exit F12=Cancel
302 Service Functions V5R2