Filter
Top Products
3. Save the main storage dump residue.
a. Use SST to enter the Main Storage Dump Manager.
b. Use the Main Storage Dump Manager to save the current main storage
dump. See “Copying a main storage dump” on page 272.
Additional help
For details on main storage dump information, see the iSeries Licensed Internal Code
Diagnostic Aids - Volume 1 information.
To save the dump data to removable media, see “Copying a main storage dump”
on page 272.
Performing an IOP storage dump to disk (Models 150, 170, 250, 4xx,
50x, 51x, 530, 53S, 6xx, 7xx, SB1, S20, S30, and S40)
Perform the following to obtain a storage dump of the MFIOP card:
1. Select Manual mode.
2. Select control panel Function 25 (service switch 1 function).
3. Press Enter on the control panel.
4. Select control panel Function 26 (service switch 2 function).
5. Press Enter on the control panel.
6. Select control panel Function 70 (MFIOP storage dump).
7. Press Enter on the control panel.
8. Wait for one of the following completion SRCs:
a. 11xx A1XX8ABF
b. 11xx B1XX8ABF
c. 11xx D1XX8ABF
9. The data is now written to disk.
10. Save the MFIOP data for the storage dump to tape or diskette (See “Copying
the IOP storage dump to removable media (All Models)” on page 278).
This ends the procedure.
Performing a service processor storage dump (Models 270, 8xx, SB2,
SB3, and 890)
Perform the following to obtain a storage dump of the service processor card:
1. Select Manual key mode.
2. Select control panel Function 25 (service switch 1 function).
3. Press Enter on the control panel.
4. Select control panel Function 26 (service switch 2 function).
5. Press Enter on the control panel.
6. Select control panel Function 70 (service processor control storage dump).
7. Press Enter on the control panel.
8. Wait for the status SRCs to complete (D1xx 380x followed by 00 status
displayed).
9. The data is now saved to a non-volatile storage area.
Chapter 10. Working with Storage Dumps 277