Filter
Top Products
SCSI Registers 4-43
AIP Arbitration in Progress 4
Arbitration in Progress (AIP = 1) indicates that the
LSI53C875A has detected a Bus Free condition, asserted
SBSY, and asserted its SCSI ID onto the SCSI bus.
LOA Lost Arbitration 3
When set, LOA indicates that the LSI53C875A has
detected a bus free condition, arbitrated for the SCSI bus,
and lost arbitration due to another SCSI device asserting
the SSEL/ signal.
WOA Won Arbitration 2
When set, WOA indicates that the LSI53C875A has
detected a Bus Free condition, arbitrated for the SCSI
bus and won arbitration. The arbitration mode selected in
the SCSI Control Zero (SCNTL0) register must be full
arbitration and selection to set this bit.
RST SCSIRST/Signal 1
This bit reports the current status of the SCSI RST/
signal, and the SRST signal (bit 6) in the Interrupt Status
Zero (ISTAT0) register. This bit is not latched and may
change as it is read.
SDP0 SCSI SDP0/ Parity Signal 0
This bit represents the active HIGH current status of the
SCSI SDP0/ parity signal. This signal is not latched and
maychangeasitisread.
Register: 0x0E
SCSI Status One (SSTAT1)
Read Only
FF[3:0] FIFO Flags [7:4]
These four bits, along with SCSI Status Two (SSTAT2)
bit 4, define the number of bytes or words that currently
reside in the LSI53C875A’s SCSI synchronous data FIFO
as shown in Table 4.6. These bits are not latched and
they will change as data moves through the FIFO. The
SCSIFIFOcanholdupto31bytesfornarrowSCSI
7 43210
FF[3:0] SDP0L MSG C_D I_O
0000xxxx