Filter
Top Products
SCSI Registers 4-97
Register: 0x57
Chip Control 1 (CCNTL1)
Read/Write
ZMODE High Impedance Mode 7
Setting this bit causes the LSI53C875A to place all output
and bidirectional pins except MAC/_TESTOUT, into a
high impedance state. Also, setting this bit causes all I/O
pins to become inputs, and all pull-ups and pull-downs to
be disabled. When this bit is set, the MAC/_TESTOUT
pin becomes the output pin for the connectivity test of the
LSI53C875A signals in the “AND-tree” test mode. In
order to read data out of the LSI53C875A, this bit must
be cleared. This bit is intended for board-level testing
only. Do not set this bit during normal system operation.
R Reserved [6:4]
DDAC Disable Dual Address Cycle 3
When this bit is set, all 64-bit addressing as a master will
be disabled. No dual address cycles will be generated by
the LSI53C875A.
When this bit is cleared, the LSI53C875A will generate
dual address cycles based on the master operation being
performed and the value of its associated selector
register.
64TIMOD 64-Bit Table Indirect Indexing Mode 2
When this bit is cleared, bits [24:28] of the first table entry
Dword will select one of 22 possible selectors to be used
in a BMOV operation. When this bit is set, bits [24:31] of
the first table entry Dword will be copied directly into
DNAD64 to provide 40-bit addressing capability. This bit
will only function if the EN64TIBMV bit is set.
Index Mode 0 (64TIMOD clear) table entry format:
76 43 2 1 0
ZMODE
R DDAC 64TIMOD EN64TIBMV EN64DBMV
0
x x x0 0 0 0
[31:29] [28:24] [23:0]
Reserved Sel Index Byte Count
Source/Destination Address [31:0]