Filter
Top Products
Error Messages
12-9
Troubleshooting
12
No response from the server. Check the settings.
Cause The specified server settings are incorrect, or the server is not turned ON.
Alternatively, the machine's TCP/IP resources may be low.
Remedy Wait for a while, and try browsing again. If you still fail, try selecting another
server.
NetWare is in use. Wait for a moment, then perform operation again.
Cause You cannot browse the network because NetWare is printing through a PServer
or NDS PServer.
Remedy Wait until printing is complete, and try browsing again.
There are too many sub directories.
Cause You have exceeded the maximum number of subdirectory levels allowed.
Remedy The directory level that you are trying to access cannot be specified. Specify a
different destination.
No response.
Cause 1 The server was not running when you tried to send.
Remedy Check the destination.
Cause 2 The network connection was lost when you tried to send. (Either you could not
connect to the destination or the connection was lost before the job could
complete.)
Remedy Check the status of the network.
Cause 3 You tried to send through NetWare, but the Tree name was not entered.
Remedy Enter the Tree name.
Cause 4 A TCP/IP error occurred when you tried to send an e-mail or I-fax.
Remedy Check that the network cables and connectors are properly connected.
Check the TCP/IP.
Cause The machine's TCP/IP is not operating.
Remedy Check the IP Address Settings (IP Address, DHCP, RARP, BOOTP) in TCP/IP
Settings in Network Settings in System Settings (from the Additional Functions
screen). (See Chapter 3, "Using a TCP/IP Network," in the Network Guide.)