Filter
Top Products
Displaying AppleTalk Routes
8-12 Managing AppleTalk
Displaying AppleTalk Routes
Command
Use the SHOW/MONITOR APPLETALK ROUTES command to display the
available AppleTalk routes to an access server. The command is nonprivileged.
Displaying AppleTalk Routes Example
The following example shows how to use the SHOW APPLETALK ROUTES
command to display available AppletTalk routes:
Local> SHOW APPLETALK ROUTES
AppleTalk Routes Server: LAT_08002B24F24F
Destination Next Hop Status Interface Seconds
since
Last
Validated
12344-12350 12346.132 Up Ethernet 159
<default> 12347.1 Up Ethernet 20
12349.223 12346.132 Up Asynch7 29
12348.144 12346.132 Up Asynch3 116
Fields in the AppleTalk Routes Display
The following table describes the fields in the AppleTalk routes display:
Field Value Description
Destination The route destination. This can be either an
AppleTalk network number range or an
AppleTalk host address. A host address
indicates a route to a host attached to the
access server by means of an asynchronous
link. The destination <default> is
distinguished from the others. If the server
does not find an appropriate route for a DDP
packet, it sends the packet to the route’s next
hop.
Next Hop The AppleTalk router that is the “next hop” to
a particular network. For the <default>
destination, the next hop corresponds to an
AppleTalk router. For all other destinations,
the next hop is the access server’s own
AppleTalk address.