Filter
Top Products
Displaying PPP Characteristics
19-10 Configuring and Managing Point-to-Point Protocol (PPP) Ports
ATCP Characteristics
The SHOW/LIST/MONITOR PPP ATCP CHARACTERISTICS command displays
the ATCP configuration for a given port. The fields in the display show the latest
values configured by the SET PORT
n
PPP ATCP characteristic commands. Use the
SHOW/MONITOR PORT
n
PPP ATCP STATUS command to see the values actually
used on the link.
Example: ATCP Characteristics Display
The following example shows a sample ATCP characteristics display:
Local> SHOW PORT 5 PPP ATCP CHARACTERISTICS
Port 5: Server: LAT_08002B26AA94
ATCP Characteristics:
ATCP: Enabled Passive Open: Enabled
Restart Timer: 3 seconds
Max Configure: 10 transmissions
Max Terminate: 2 transmissions
Max Failure: 10 transmissions
ATCP Characteristics Display Field Values
The following table explains the fields in the ATCP characteristics display:
Field Description Values Default
ATCP Indicates if ATCP is enabled. Enabled
Disabled
Enabled
Passive Open
1
When enabled, ATCP
negotiation does not begin until
initiated by the attached device.
Enabled
Disabled
Enabled
Restart Timer Indicates the amount of time
between ATCP configure- or
terminate-request
retransmissions when there is
no response.
1 to 5
seconds
3
Max Configure The number of times that ATCP
sends a configure-request
packet to the peer without
receiving an acknowledgment.
1 to 15
attempts
10