Filter
Top Products
Configuring and Managing Point-to-Point Protocol (PPP) Ports 19-5
Displaying PPP Characteristics
Displaying PPP Characteristics
Introduction
This section describes the commands used to display characteristics for LCP, IPCP,
and ATCP.
Displaying LCP Characteristics
Use the SHOW PORT
n
PPP LCP CHARACTERISTICS command to display LCP
characteristics for a port. This command is nonprivileged. The fields shown in the LCP
display show the latest values configured by the SET PORT
n
PPP LCP characteristic
commands. Use the SHOW/MONITOR PORT
n
PPP LCP STATUS command to see
the values actually used on the link.
Example: Displaying LCP Characteristics
The following example shows the command to display the LCP configuration for port
5.
Local> SHOW PORT 5 PPP LCP CHARACTERISTICS
Port 5: Server: LAT_08002B26D0E7
LCP Characteristics:
LCP: Enabled Passive Open: Disabled
Restart Timer: 3 seconds
Max Configure: 10 transmissions
Max Terminate: 2 transmissions
Max Failure: 10 transmissions
LCP Options: Local:
MRU: 1500
Character Map: FFFFFFFF
Link Quality: Disabled
Magic Number: Disabled
PF Compress: Disabled
ACF Compress: Disabled
FCS Size: 16 Bit
Callback Disabled