Filter
Top Products
Defining the Dialer Service
21-12 Managing Dial Services
Displaying Dialer Counters
Use the SHOW DIALER
service-name
COUNTERS command to display the counters
for a dialer service.
Example: Show Dialer Counters
The following example shows the dialer service counters display for the dialer service
AT_TRADESHOW:
Local> SHOW DIALER AT_TRADESHOW COUNTERS
Dial Service: AT_TRADESHOW
Seconds Since Zeroed: 1989692 Failures: 17
Connections Attempted: 113 Busy: 10
Connections Completed: 96 No Answer: 0
No Dial Tone: 0 No Response: 0
No Carrier: 0 Authentication: 7
Unknown: 0
Local>
Modifying the Dialer Service
Use the SET/DEFINE/CHANGE DIALER SERVICE
dialer-service-name
command
to define the dialer service. The
dialer-service-name
characteristic is a string of 1 to 16
characters.
The dialer service name must be unique to the server. Before you create a new dialer
service, use the SHOW DIALER SERVICE command to verify that the new name
does not conflict with that of an existing dialer service.
For a detailed explanation of command keywords used to mange dialer services, see
the Command Definitions section in Chapter 2.
Example: Change Dialer Name
The following example uses many of the keyword options in the command line:
Local> CHANGE DIALER on_the_road PORT 4-9 IDENT "Dial-back"
Local> CHANGE DIALER on_the_road NUMBER "*" MODE *