Filter
Top Products
Remote Console Port
2-10 Management Tools
Example: Using MOP to Connect to an Access Server from a DECnet/OSI
OpenVMS Node
The following example shows a connection from a DECnet/OSI OpenVMS node to an
access server remote console port. In this example:
•
The access server has a DECnet node name of DGD700.
•
The maintenance password is FEDCBA. On the SET HOST/MOP command line,
however, the DECnet/OSI software transposes this password into the string
BADCFE.
•
The access server has a password of ACCESS.
$ SET HOST/MOP DGD700/VERIFICATION=%XBADCFE
%CCR-I-CONNEST, connection established to remote system
08-00-2B-26-AE-32 Press CTRL/ \ to disconnect, CTRL/] to send
break
# ACCESS (not echoed)
Network Access SW Vx.x for DSxxx-xx BLxx-xx ROM Vx.x-x
Uptime: 0 00:16:41
(c) Copyright 1993, Digital Equipment Corporation -
All Rights Reserved
Please type HELP if you need assistance
Enter username> SWINSTALLER
Local>
Use of CCR from an ULTRIX DECnet Node
Console Carrier Request (CCR) enables you to connect to the remote console port from
an ULTRIX DECnet node that is on the same Ethernet as the access server. The node
must be running ULTRIX MOP software, but does not need to be a LAT service node
or load host for the access server.
To disconnect from the access server, press Ctrl/D. To exit CCR, type EXIT or press
Ctrl/Z. For more information about CCR, refer to the DECnet documentation provided
with your system.