Filter
Top Products
Managing Dial Services 21-7
Assigning the Dialer Script to a Port
Example: The Show Port Command Display
The following example shows the resulting display for the SHOW PORT command.
In this example, the preferred dialer service is CALL_HOME and the dialer script
name is Generic_14400.
Local> SHOW PORT 2
Port 2: Server: user10_DS700-16
Character Size: 8 Input Speed: 57600
Flow Control: XON Output Speed: 57600
Parity: None Signal Control: Enabled
Stop Bits: Dynamic Signal Select: CTS-DSR-RTS-DTR
Access: Dynamic Local Switch: None
Backwards Switch: None Name: PORT_2
Break: Local Session Limit: 4
Forwards Switch: None Type: Ansi
Default Protocol: DIAL Default Menu: None
Dialer Script: Generic_14400
Preferred Service: CALL_HOME
Authorized Groups: 0
(Current) Groups: 0
Enabled Characteristics:
Autoconnect, Autoprompt, Broadcast, DSRlogout, Failover, Inac-
tivity Logout, Input Flow Control, Lock, Loss Notification, Mes-
sage Codes, Output Flow Control, PPP, SLIP, Verification
Local>
Assigning a Dialer Script to a Port
Use the SET/DEFINE/CHANGE PORT
n
DIALER SCRIPT command to assign a
dialer script to a port.
Example: Defining the Dialer Script
The following example shows how to assign the dialer script dickens to port 2. After
you enter this command and initialize the access server, the SHOW PORT display for
port 2 will reflect this change.
Local > DEFINE PORT 2 DIALER SCRIPT dickens